Our system consists of a base plate and post. The base plate can be welded to the structural beams in the fabrication shop or in the field. The posts are then screwed into the base plates.  If concrete is to be poured, we provide a protective plastic sheath to slide over the bottom of the post to facilitate easy removal at the end of the job. The posts support the wire cable at the perimeter of the building and can be easily removed and re-used on future buildings. The base plates become part of the building and at the roof level can be uncovered for future use as tie-off points with our fall arrestor accessory.

Perimeter Protection Products LLC supplys base plates that will attach to many different structures. They can be: welded to steel structures, imbedded in "poured in place" concrete structures, fastened to wood blocking, pre-cast concrete, or hollow core concrete planks, clamped to I-Beams, clamped to parapets, and many others.

Our system eliminates 87% of the exposure at the edge of the building and saves a significant amount of labor during installation and even more during the removal. We have designed our system to be re-usable and to protect workers at the edge of the roof, lower floor perimeter, as well as, the stairwell and elevator shafts. It was designed to eliminate the currently used angle iron that is being welded into the roof and lower floor beams that later needs to be cut off, ground down and thrown out.

Besides saving on labor costs for installation and removal, our posts can be re-used. On high-rise buildings, re-use them on the higher floors after you close in the lower ones, and then re-use them on the next building, saving you even more money.