42" Standard Post

Part Number 1965-10

Our 42" Post screws into any of our base plates to provide a support stanchion for cables at 42" and 21" heights. Cable height can be adjusted using appropriate base plates. Posts provide an OSHA compliant 200-pound side load and a 5,000 pound tie-off point provided base plates are attached appropriately. Locking cable guides accept cable up to 1/2" in diameter. Plastic sheath is provided to allow easy removal of post in situations where concrete is poured around post. No tools are required, allowing for fast installation and removal.

Cable, turn buckles and crosby clamps are to be supplied by others.

Installation: Screw posts fully into the base plates and run up to a 1/2" diameter cable (supplied by others) through cable locks and tension per OSHA standards with 1/2" turn buckles. Clips are to face the interior of building with cables installed on the interior side of posts/building. POST CAN BE USED FOR A TIE-OFF FOR ONE MAN ONLY. TIE-OFF MUST BE BETWEEN UPPER AND MID CABLE ONLY. Ensure all posts and accessories are fully screwed into base plates before use.

Warning - System does not allow for a tie-off to cable.



Calculate Your Savings
calculate


Calculate Bonus Savings on Debris
Netting Installation-Removal
calculate